HP Integrity rx1600 Operation and Maintenance Guide

Chapter 7
Removing and Replacing Components
Removing and Replacing the System Battery
148
Step 10. Connect the power pod cable to the power connector on the system board.
Figure 7-23Connecting the Power Cable
Step 11. Replace the cover.
Step 12. Verify that the newly installed processor works:
• Run the info cpu command at the EFI shell prompt, or
• Check the configuration using the EFI System Configuration menu.
Removing and Replacing the System Battery
Systems with an optional management processor card have two batteries. Systems with no management processor card have
only one battery. The main system battery is located on the system board. The battery is 3.3 VDC, BR-type with 250 mAh.
NOTE Date, time, and customer settings being cleared are a common indication of the need to replace the system
battery.
Removing the System Battery
Step 1. Turn off the system and disconnect all cables.
Step 2. Remove the cover. See “Removing and Replacing the Cover”.
Front of server