HP Integrity rx1600 Operation and Maintenance Guide

Chapter 7
Removing and Replacing Components
Removing and Replacing an Internal Hard Disk Drive
162
Replacing an Internal Hard Disk Drive
One additional disk drive may be added to your HP Server in slot 1. Always use low profile disk drives (1.0” height) in your
hp Integrity rx1600.
To install or replace an internal disk drive, perform the following steps:
Step 1. If installing an additional drive, remove the slot filler that is installed in slot 1. If replacing a disk drive, the slot
will be empty due to the disk drive being previously removed.
Figure 7-35Removing Disk Drive Slot Filler
Step 2. Slide the hard disk into the vacant SCSI cage slot until it is seated.