HP Integrity rx1600 Operation and Maintenance Guide

Chapter 7
Removing and Replacing Components
Removing and Replacing the Power Supply
164
Step 1. Remove the cover. See “Removing and Replacing the Cover”.
Step 2. Remove the power supply fan unit from the chassis. See “Removing and Replacing Fan Units”.
Step 3. Slide the power supply forward in the chassis releasing the power supply connection to the power distribution unit.
Figure 7-37Power Supply Removal/Replacement
Step 4. Carefully lift the power supply cable free from all retaining clips.
Step 5. At the rear of the chassis, remove the two screws holding the power receptacle to the chassis.
Step 6. Lift the power supply forward and away from the chassis to remove. The power receptacle and cord are integral
components of the power supply.
Replacing the Power Supply
To replace the power supply, perform the following steps:
Step 1. Perform the power supply removal procedure described above.
Step 2. Place the replacement power supply into the chassis slot at the front of the power distribution unit.