HP Integrity rx1600 Operation and Maintenance Guide

Chapter 7
Removing and Replacing Components
Removing and Replacing the Optional Management Processor Card
169
b. Screw in the two mounting screws that connect the MP card to the internal chassis post.
Figure 7-41Connecting the Management Processor Card
Step 6. Screw in the two external mounting posts that are located on both sides of the 25-pin serial connector.
Figure 7-42Installing the External Mounting Posts
Step 7. Replace the system cover(s) and reconnect the power and external cables.
Information required to access, configure and to utilize the management processor is provided in Chapter 5, “Utilities.”