HP Integrity rx1600 Operation and Maintenance Guide

Chapter 2
Controls, Ports and Indicators
Rear Panel
22
10/100 base-T ethernet LAN Connector
The rear panel 10/100 base-T ethernet LAN connector has the following status and activity LEDs.
Figure 2-7 10/100 base-T ethernet LAN Connector LEDs
Optional Management Processor Card LAN LEDs
The optional management processor LAN uses an RJ-45 type connector. This connector has four LEDs that signal status and
activity.
Figure 2-8 Optional Management Processor Card LAN LEDs
Table 2-6 10/100 base-T ethernet LAN Connector LEDs
LED Description
Speed (yellow) Off—port linked at 10Mbps, On—port linked at 100Mbps
Activity (green) Off—no link established, On—port linked
Table 2-7 Optional Management Processor Card LAN LEDs
LED Description
Self-test Yellow—MP is running self-test or error detected
10BT Green—10BT link established, blinking green—10BT link activity, off—no link
100BT Green—100BT link established, blinking green—100BT link activity, off—no link
Speed (Yellow)
Activity (Green)
1234 567 8
Self-test
10BT
100BT
Standby power