HP Integrity rx1600 Operation and Maintenance Guide

Chapter 4
Installing and Configuring
Installing Processors and Memory
33
CAUTION When sliding the hard disk drive into the slot, be careful not to damage the EMI shielding of the
drive. The drive should fit into the slot without excessive use of pressure.
Figure 4-3Disk Drive Installation in Slot 1
Step 3. Close the drive-ejector handle by pushing it down until it clicks.
Step 4. The hard disk drive is now correctly installed.
Step 5. Validate the hard disk drive installation by:
a. If the server does not have a management processor installed, at the EFI shell prompt input shell> info io
to interrogate the system for proper identification of the drive.
b. If the server has a management processor installed, use the management processor command MP> sl e to
display the system system event log and examine for proper identification of the drive.
Installing Processors and Memory
This section provides information about installing processors and memory. The processors and memory slots are located on
the system board, which is accessible by removing the system cover.
WARNING Voltages are present at various locations within the server whenever an AC power source is connected.
This voltage is present even when the main power switch is in the off position.