HP Integrity rx1600 Operation and Maintenance Guide

Chapter 4
Installing and Configuring
Installing Additional PCI Cards
44
•Run the info mem command at the EFI shell prompt, or
•Run memdiag from the Offline Diagnostics DC to insure that the memory is functional.
Installing Additional PCI Cards
The server may contain up to 2 PCI cards. PCI cards are located on the I/O riser assembly.
WARNING Ensure that the system is powered-down and all power sources have been disconnected from the server
prior to removing or replacing a PCI card.
Voltages are present at various locations within the server whenever an AC power source is connected.
This voltage is present even when the main power switch is in the off position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety
precautions could result in damage to the server.
Carefully read the following information concerning PCI slot configuration. Inserting a PCI card into a slot that is not
configured to accept it may cause operation failure or the PCI card to operate at less than optimum speed. PCI slots are
numbered 1 and 2. See the labels on the rear panel of the chassis for correct PCI slot number identification.
The following describes configuration requirements for slots 1 through 2:
• Slot 1(top) is a single, full size PCI slot that runs at 133MHz.
• Slot 2 (bottom) is a single, half-size PCI slot that runs at 133MHz.
Installing a PCI Card
To install a PCI card in the server, perform the following steps:
CAUTION Record the location of all PCI cards as they are installed. Depending on the operating system, replacing the
PCI card in a different location might cause boot failure.
Step 1. Remove the cover. See “Removing and Replacing the Cover”.