HP Integrity rx1600 Operation and Maintenance Guide

Chapter 4

Installing and Configuring

Installing Additional PCI Cards

Step 4. Remove the PCI slot cover.

Figure 4-19Removing a PCI Slot Cover

Step 5. Grasp the edges of the PCI card being installed and gently press the connector into the PCI I/O riser connector.

NOTE Full length PCI cards may only be installed in slot 1, the top slot of the PCI I/O riser assembly.

The lower slot (slot 2) can only accept half length cards.

Figure 4-20Installing a PCI Card

Step 6. Insert the card mounting screw and secure with a T-15 driver.

Step 7. Replace the PCI I/O riser assembly by positioning the connector over the mating connector on the system board

and then turning the jackscrew to complete the connector mating.

Step 8. Connect any cables that are required by the PCI card.

Step 9. Replace the cover. See “Removing and Replacing the Cover”.