HP Integrity rx1600 Operation and Maintenance Guide

Chapter 5
Utilities
Specifying SCSI Parameters
70
Ctrl[0E] Acpi(HWP0002,700)
Ctrl[1A] Acpi(HWP0002,700)/Pci(1|0)
Ctrl[1B] Acpi(HWP0002,700)/Pci(1|1)
Ctrl[36] 16550 Serial UART Driver
Ctrl[37] VT-100+ Serial Console
Ctrl[31] Primary Console Input Device
Ctrl[32] Primary Console Output Device
Ctrl[30] Primary Standard Error Device
Ctrl[1C] Acpi(HWP0002,700)/Pci(2|0)
Ctrl[32] Primary Console Output Device
Ctrl[30] Primary Standard Error Device
Ctrl[33] Acpi(PNP0501,0)
Ctrl[34] 16550 Serial UART Driver
Ctrl[35] VT-100+ Serial Console
Ctrl[31] Primary Console Input Device
Ctrl[32] Primary Console Output Device
Ctrl[30] Primary Standard Error Device
Ctrl[44] VenHw(904EFCF0-F0A8-11D4-B4CA-303031303833)
Ctrl[46] VenHw(D65A6B8C-71E5-4DF0-A909-F0D2992B5AA9)
In the above example, the SCSI interface information is shown highlighted bold. You can tell the information is for
the SCSI interface because the path on the first line—Acpi(HWP0002,100)— is the path from the information
displayed by the infoio command. The next two lines are for the SCSI interface two channels, one line for each
channel (they contain the SCSI interface description [LSI Logic Ultra160 SCSI Controller]). Note the value shown for
Ctrl—17 and 18—at the beginning of each of those lines; this is the controller’s handle for each channel. You need
to know it for the next step.
NOTE The controller’s handle values will change on every boot.
Step 3. Still at the EFI shell prompt, type this command to obtain the EFI driver’s handle for the SCSI interface:
drvcfg
A list of all EFI-capable configurable components in the system is displayed. The output may look like this:
Shell> drvcfg
Configurable Components