HP Integrity rx1600 Operation and Maintenance Guide

Chapter 5
Utilities
Management Processor Command Interface
89
This command displays and allows modification of the LAN configuration. Configurable parameters include:
•MP IP Address
•MP Host Name
• Subnet Mask
• Gateway Address
• Web Console port number
• Link State
The MP Host Name set in this command is displayed at the MP command interface prompt. Typically the DNS name for the
LAN IP is entered.
This field can be programmed to any useful name or phrase. For clarity, it is useful to enter MP-on-SYSTEM as the MP Host
name, so both names show up in the prompt (limit 19 characters, no spaces allowed.) The web access port number is also set
by this command.
Locator LED Status
LOC: Locator LED Status
This command displays the current status of the Locator LED.
LAN Status
LS: LAN Status
This command displays all parameters and the current status of the MP LAN connections. The LAN parameters are not
modified by the execution of this command.
Return to Main Menu
MA: Return to MP Main Menu
This command makes the MP return to the non mirrored MP Main Menu. This is the same as executing CTRL+B.
Modem Reset
MR: Modem Reset
This command makes the MP send an AT Z command to the modem, which resets it. Any modem connections are lost. The
initialization results can be viewed via the MS command.
Modem Status
MS: Modem Status—Display modem status
The MS command displays the state of the modem lines connected to the remote/modem serial port. The display can be
updated by pressing
Enter. The current state of the status signals DCD, CTS, DSR, RI and the last state of the control signals
DTR, RTS set by the firmware are displayed.
Power Control
PC: Power Control—turn system power on and off