HP Integrity rx1600 Operation and Maintenance Guide

Chapter 5

Utilities

Management Processor Command Interface

If the local console client user did not originate the MP command interface session, there is always one default user listed for

the local serial port: local user i. If the local console operator types

CTRL+B, then the login name that the local operator used

is displayed instead.

Exit from MP

X: Exit from MP command interface and disconnect from the system

This command disconnects the executing user from the system. This command is available from the local port.

Diagnostics

XD: Diagnostics and/or Reset of MP

This command allows the user to perform some simple checks to confirm the MP's health and its connectivity status. The

following tests are available:

• MP Parameter Checksum

• Verify I2C connection (get BMC Device ID)

• LAN connectivity test using ping

• Modem self-tests

Also, the MP can be reset from this command. A MP reset can be safely performed without affecting the operation of the

server.