Installation Guide, Second Edition - HP Integrity rx1600

Cable Connections

Booting the Server

Chapter 5

Booting the Server

To boot the server, perform the following step.

Step 1. Depress the power switch located to the right of the Front Panel LEDs.

If the autoboot function is enabled, the system will boot to the installed operating system. If autoboot is not

enabled, the system will enter the EFI Boot Manager. The EFI Boot Manager allows you to control the

server’s booting environment. For more information about the EFI Boot Manager, review the Utilities chapter

of the Operations and Maintenance Guide.

SE Activate a system session on Locator Remote Port

SL Show Logs

SO Security Options and Access Control

SYSREV Display all Firmware revisions

SS System Status of Processor Modules

TC Transfer of Control-System reset through INIT signal

TE Tell-Send a Message to Other Users

UC User Configuration

VT Display software trace

VFP Virtual Front Panel

WHO Display Connected management processor Users

XD MP Diagnostics and/or Reset

Table 5-1 Management Processor Commands and Descriptions (Continued)

Command Description