Installation Guide, Second Edition - HP Integrity rx1620

Chapter 3
Installing and Configuring
Installing Processors and Memory
26
Step 2. Close the cover by moving the latch handle clockwise.
Figure 3-11 Closing the Cover
Installing Processors and Memory
This section provides information about installing processors and memory. The processors and memory slots
are located on the system board, which is accessible by removing the system cover.
WARNING Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in
the off position.
Ensure that the system is powered-down and all power sources have been
disconnected from the server prior to attempting the following procedures.
Failure to observe this warning could result in personal injury or damage to
equipment.
CAUTION Do not operate the server without the cover in place. Operation of the server without the cover
in place may result in server failure. Operation of the server without the cover in place will
make the server susceptible to EMI problems.
CLOSED
OPEN
Front of Chassis