Installation Guide, Second Edition - HP Integrity rx1620

Chapter 3
Installing and Configuring
Installing Additional PCI Cards
38
Step 7. Verify that the newly installed memory works:
•Run the info mem command at the EFI shell prompt, or
•Run memdiag from the Offline Diagnostics DC to ensure that the memory is functional
Installing Additional PCI Cards
The server may contain up to 2 PCI cards. PCI cards are located on the I/O riser assembly.
WARNING Ensure that the system is powered-down and all power sources have been
disconnected from the server prior to removing or replacing a PCI card.
Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning could result in personal injury or damage to
equipment.
CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server.
Carefully read the following information concerning PCI slot configuration. Inserting a PCI card into a slot
that is not configured to accept it may cause operation failure or the PCI card to operate at less than optimum
speed. PCI slots are numbered 1 and 2. See the labels on the rear panel of the chassis for correct PCI slot
number identification.
The following describes configuration requirements for slots 1 through 2:
• Slot 1(top) is a single, full size PCI slot that runs at 133MHz.
• Slot 2 (bottom) is a single, half-size PCI slot that runs at 133MHz.
Installing a PCI Card
To install a PCI card in the server, perform the following steps:
CAUTION Record the location of all PCI cards as they are installed. Depending on the operating system,
replacing the PCI card in a different location might cause boot failure.
Step 1. Remove the cover. See “Removing and Replacing the Cover”.