Installation Guide, Second Edition - HP Integrity rx1620

Cable Connections

External Core I/O Connections

Chapter 5

Web Console Port Number: 2023

Do you want to modify the LAN hardware configuration? (Y/[N])

Do you want to modify the LAN configuration? (Y/[N]) y

NOTE The value in the “IP address” field is set at the factory. The customer must provide

the actual management processor LAN IP address.

Step 2. At the prompt, Do you want to modify the Lan hardware configuration?, enter y.

The current IP address is shown; then the following prompt appears: Do you want to modify it?

(Y/[N])

Step 3. Enter y.

Step 4. Enter the new IP address.

Step 5. Confirm the new address.

Step 6. Enter the management processor Network Name.

This is the host name for the management processor LAN. The name can be as many as 64

characters, and include alpha numerics, - (dash), _ (under score),. (period), or a space.

Step 7. Enter the LAN parameters for Subnet mask and Gateway address, and Web Console Port

Number.

Step 8. Once step 7 is completed, the system will prompt for changes to the LAN hardware configuration. It

is recommended that this prompt be answered with no by entering n.

Step 9. The system will now indicate that the LAN settings have been updated and that the MP must be

reset to initiate these changes. At the management processor menu prompt (MP>), check the LAN

parameters and status with the LS command to confirm the new LAN settings. After confirmation,

use the R option of the XD command to reset the MP.

Step 10. Use the EL command to enable/disable web console and telnet access after the MP has been reset.

Management Processor Commands

Table 5-1 Management Processor Commands and Descriptions

Command Description

BP Reset BMC passwords

CA Configure Serial Port parameters

CE Log a repair in the history buffer

CL Display Console history

CG Certificate Generator

CO Return to Redirected Console Mode

CSP Connect to another service processor