Operations Guide, Fourth Edition - HP Integrity rx1620

Return to Main Menu
MA: Return to MP Main Menu
This command makes the MP return to the non mirrored MP Main Menu. This is the same as
executing CTRL+B.
Modem Reset
MR: Modem Reset
This command makes the MP send an AT Z command to the modem, which resets it. Any modem
connections are lost. The initialization results can be viewed via the MS command.
Modem Status
MS: Modem Status—Display modem status
The MS command displays the state of the modem lines connected to the remote/modem serial
port. The display can be updated by pressing Enter. The current state of the status signals DCD,
CTS, DSR, RI and the last state of the control signals DTR, RTS set by the firmware are displayed.
Power Control
PC: Power Control—turn system power on and off
For proper system shutdown, shutdown the OS before issuing this command or use the commands
graceful shutdown option.
This command allows you to switch the system power on or off. the user can have the action
take place immediately or after a specified delay.
Notice this is roughly the equivalent to turning the system power off at the front panel switch.
There is no signal sent to the OS to bring the software down before power is turned off. To turn
the system off properly. you must ensure that the OS is in the proper shutdown state before
issuing this command. Use the proper OS commands or use the graceful shutdown option of
the Remote Power Control command.
Configure Paging
PG: Paging parameter setup—configures pagersThis command allows the user to configure the
pagers and set triggering events.A string description of the triggering event will be sent with
the page.
Power Status
PS: Power status—display the status of the power management module
This command displays on the console the status of the power management module.
Reset BMC
RB: Reset BMC
This command resets the BMC by toggling a GPIO pin.
Reset System
RS: Reset system through RST signal
IMPORTANT: Under normal operation, shut down the OS before issuing this command.
This command causes the system (except the MP) to be reset through the RST signal.
Management Processor Command Interface 67