Windows Integrity Management Agents Reference

10104
10105
10115
Clear NVRAM and reset.NVRAM is full. This is extremely unlikely.10116
Replace PDH daughtercardBad RTC chip on the PDH daughtercard.10132
Contact your HP support personnel.
An uncorrectable PAA fault has occurred on the
MX2 module and PAA firmware has halted.10159
Collect IPMI event logs for more information
regarding the failure. Contact your HP Support
Representative to investigate the fabric
subsystem.An error prevented the use of a fabric link.10209
Contact your HP Support Representative to
investigate the fabric and firmware vertex
modules.
An error occurred while reading a hardware
register. Other events should detail the error.10272
Contact your HP Support Representative to
investigate the fabric and firmware vertex
modules.
An error occurred while writing a hardware
register. Other events should detail the error.10273
Contact your HP Support Representative to
investigate the fabric and firmware vertex
modules.
A fabric error occurred while preparing for
rendezvous10343
Remove DIMMs to get the total memory size
below the amount of memory returned in the
data field
Too much memory has been installed in the
system.10351
Contact your HP Support Representative to
investigate the fabric and firmware vertex
modules.Experienced an error while routing the fabric.10357
Contact your HP Support Representative to
investigate the fabric and firmware vertex
modules.Experienced an error while routing the fabric.10358
Contact HP support.
System firmware did not get a completion status
from a command to a memory buffer chip.10361
Contact your HP Support Representative to
investigate the fabric and firmware vertex
modules.An unsupported fabric call was made.10375
Contact your HP Support Representative to
investigate the fabric and firmware vertex
modules.Internal firmware error.10376
Capture IPMI event logs, look for additional
errors. Contact your HP Support Representative
to analyze the fabric
System firmware was unable to read a fabric
hardware register.10377
Capture IPMI event logs, look for additional
errors. Contact your HP Support Representative
to analyze the fabric
System firmware noticed a discrepancy from the
expected topology of the system.10378
Capture IPMI event logs, look for additional
errors. Contact your HP Support Representative
to analyze the fabric
System firmware found a discrepancy in the
expected topology of the system.10379
Capture IPMI event logs, look for additional
errors. Contact your HP Support Representative
to analyze the fabric
System firmware found a discrepancy in the
expected topology of the system.10380
Platform Events – Table 2 (Windows System Log Event ID, Cause, Recommended Action) 107