Windows Integrity Management Agents Reference
Check system backplane power board.
System backplane power board has reported a
3.3v house keeping fault.11456
Check system backplane power board.
System backplane power board has reported a
12v fault.11459
Check system backplane power board.
System backplane power board has reported a
3.3v fault.11461
Check system backplane power board.
System backplane power board has reported a
1.5v fault.11463
Check system backplane power board.
System backplane power board has reported a
2.5v fault.11465
look for additional events describing action to
take.
There has been multiple faults on the same power
rail.11467
Check RCS assembly.RCS assembly has reported a fault.11468
Check HSO assembly.
HSO assembly has reported a fault or has been
removed.11471
Check HSO assembly.
Operating frequency of the HSO does not match
that of the RCS.11478
11479
look for additional events describing action to
take.
HSO assembly has been removed or has a fault
condition.11481
Look for additional events describing action to
take.
There are no HSO present or all clock sources
have faulted.11482
check HSO + RCS boardsdevice is not accessible over i2c11483
check HSO and RCS boardsdevice is not accessible over i2c.11484
check backplane power.device is not accessible over i2c.11485
check backplane powerdevice is not accessible over i2c.11486
check backplane power.device is not accessible over i2c.11487
check backplane powerdevice is not accessible over i2c.11488
check backplane power. The physical location of
the MOAB reporting the error is provided by data
field. 0xFFFFXXFFFFFFFFFF where XX is: XX =
0x00 - Moab 0x00 XX = 0x01 - Moab 0x01 XX =
0x02 - Moab 0x02 XX = 0x10 - Moab 0x40 XX =
0x11 - Moab 0x41 XX = 0x12 - Moab 0x42
SBS block for one of the MOAB's has reported an
error on startup.11489
Check power status of IO backplane.IO backplane LPM is not accessible over i2c.11495
Check power status of IO backplane.IO Backplane LPM is not accessible over i2c.11496
Update the system software
System Software Defect - using the wrong entry
address for the owner of the CPU.11515
Collect IPMI event logs, and contact your HP
support representative to inspect the fabric and
system firmware.An error occurred while routing the fabric11521
Use the soft partitioning configuration tool
released with the OS product to reconfigure the
fPar and reboot the partition. A cold reset of the
hard partition may be required
The fPar whose ID is identified in the event detail
is disabled from booting because it has no
bootable, healthy CPU. It may not own any CPU
or the CPUs it owns are Unhealthy (or
deconfigured)11529
Platform Events – Table 2 (Windows System Log Event ID, Cause, Recommended Action) 115