Windows Integrity Management Agents Reference

Collect IPMI event logs, and contact your HP
support representative to inspect the fabric and
system firmware.An error occurred while routing the fabric.11585
Collect IPMI event logs, and contact your HP
support representative to inspect the fabric and
system firmware.An error occurred while routing the fabric.11586
Collect IPMI event logs, and contact your HP
support representative to inspect the fabric and
system firmware.An error occurred while routing the fabric.11597
Collect IPMI event logs, and contact your HP
support representative to inspect the fabric and
system firmware.An error occurred while routing the fabric.11598
Collect IPMI event logs, and contact your HP
support representative to inspect the fabric and
system firmware.An error occurred while routing the fabric.11599
Reduce memory usage by other programs, add
physical memory, verify sufficient swap space,
or configure the guest to use less memory.Memory could not be allocated for the guest.11603
Reduce memory usage by other programs, add
physical memory, or configure the guest to use
less memory.
This can be caused by insufficient physical
memory.11604
Add processors or reconfigure the guest to use
fewer processors.
The number of physical processors is too few to
run the guest as configured.11605
See the HPVM guest operation log for additional
information.
The guest detected an error and could not
continue.11607
Possibly insufficient physical memory. Add
memory or reduce size of guest.Kernel driver was unable to lock memory pages11696
If this continues to occur, reinstall the software.
If this does not fix the problem contact your HP
support representative.
An incorrect calling sequence has occurred or an
image is corrupt.11700
Check the configuration and set all bus numbers
to supported values.Improper configuration11702
Modify the configuration to use a supported CPU
generation
The configuration contains an unsupported CPU
generation11703
Verify that the configuration contains the correct
UART type.
The ISA UART code was called when a PCI
UART structure and no ISA UART structure were
created.11705
Check the configuration
The device is not configured or is not the proper
type.11706
Check the configuration and verify the deviceThe device does not exist or is not available11707
Restart the virtual machine. If this fails verify that
it is properly installed.
The virtual machine software is not properly
installed or is not running11708
Add memory or reduce memory use
The PMAN kernel has insufficient memory
available to create a guest11709
Verify that the root file system has no errors and
is not full.Insufficient resources or file system problem11710
Verify that the root file system has no errors and
that the PMAN has sufficient memory.
File system error or PMAN has insufficient
resources11711
Start HPVMHPVM has not been started11712
Reduce guest resources or add memoryInsufficient resources11718
Platform Events – Table 2 (Windows System Log Event ID, Cause, Recommended Action) 117