Windows Integrity Management Agents Reference

Call HP supportOS or firmware bugs11932
Call HP supportSoftware data corruption11933
Contact Engineering, This is a bug.11960
Contact Engineering, This is a bug.11961
Contact Engineering, This is a bug.11962
Contact HP support. When this event is emitted,
cell online add/delete is not usable.
Cell online add/delete was attempted but the
colad subsystem failed to initialize.11964
Do not use COLAD is FPARs mode
FPARs component on which cell on line
add/delete depends is broken or missing.11966
Do not use cell on line add/delete in FPARs mode.
Cell on line add/delete in FPARs mode failed to
get the FPARs semaphore.11967
Do not use cell on line add/delete in FPARs mode
More than one processor from an FPAR called
into cell on line add/delete11968
Do not use cell on line add/delete in FPARs mode
All FPARs processors failed to rendezvous during
a cell on line add/delete operation.11969
Existing partition can continue to run, new cell
cannot be added to the partition.
New cell cannot communicate with existing
partition. Cell OLA failed.11970
For Fpars/Vpars, system FW will reset the hard
partition. For npars, system FW will still attempt
to hand off to the OS_MCA handler, if OS_MCA
handoff fails, the hard partition will get reset.
An MCA happened before a previous MCA event
did not complete.11971
For Fpars/Vpars, system FW will reset the hard
partition. In Npars mode, MCA handler will
attempt to hand off to OS_MCA handler. If
handoff fails, the hard partition will be reset.
An MCA event happening before a previous INIT
event was not completely processed.11972
Check for intermittent link errors. Capture IPMI
event logs and look for additional error events.
Contact your HP Support Representative to
investigate the fabric.The bad edge could not be found.11974
11989
The partition is rebooted to nPars to allow the
soft partition to be re-configured.
A soft partition could not be booted. Please refer
to previous events for the complete details.12001
Capture IPMI event logs. Contact your HP
Support Representative to investigate the fabric
subsystem.
A traversable route between the local cell and the
specified destination crossbar could not be found12008
Reset partitionInternal FW error.12013
Replace all DIMMs in the memory rank specified
in the physical location info. If problem persists,
contact HP support to troubleshoot the problem.
An uncorrectable memory ECC error has
occurred.12017
Collect IPMI event logs and contact your HP
Support Representative to investigate the fabric
system firmware subsystem
Unexpected error retrieving information from
the fabric graph.12025
Collect IPMI Logs and contact your HP Service
Representative to investigate the fabric
subsystem.
System Firmware encountered an error while
reading a fabric crossbar chip.12028
Collect IPMI Logs and contact your HP Support
Representative to investigate the fabric
subsystem.
System Firmware could not establish routing
from the local crossbar that would be needed to
complete the route around routing.12029
Contact HP for support
An invalid, non supported TPM is being used in
the system12047
Platform Events – Table 2 (Windows System Log Event ID, Cause, Recommended Action) 119