Windows Integrity Management Agents Reference

Contact HP Service for assistance.
The processor has experienced an excessive
number of persistent correctable errors in its third
level cache and as a result performance has
degraded. Normally the processor can
dynamically deal with this type of error with no
impact on performance. However, if too many
such errors occur then they begin to impact
performance. The processor is still able to operate
correctly but its performance is degraded so it
should be replaced.12343
Flash a new alternate ROM supported by the
platform.
The alternate ROM does not contains a valid
signature. It is not a supported ROM for this
system or it does not come from HP12352
Check the BMC firmware, flash a new BMC
firmware. If problem persists, contact HP support
to troubleshoot the problem.
The BMC did not respond to the ROM swap
command12354
Replace the faulty card
PCI/PCIx/PCIe card/slot hardware failure caused
error during IO bus scan Additional data may be
available via EFI 'info io' command12358
Check that the two cell boards are firmly seated
in the backplane. If problem persists, notify the
Call Center for assistance.
Possible bad connection between cell and
backplane.12394
Provide console log containing register dump to
HP Customer Engineer.
Probable bug in System Firmware, EFI driver,
EFI app or OS loader (prior to OS launch).12395
Try installing SVB in a different location.
The "e-keying error" only occurs during the
power-up if the SVB must be left off due to an
electronic keying problem.12399
SVB must be installed in specific positions relative
to fans or other components.SVB inserted in an improper location.12400
More fans may be needed for sufficient cooling.
The "cooling error" occurs during the power-up
if the SVB must be left off due to insufficient
cooling.12401
Reset cell that emitted the event.Firmware internal data corruption.12403
Try issuing the requests after some time. If the
problem exists even after subsequent requests,
please contact the HP representative.
If Onboard Administrator is busy in processing
another requests, then it sends BUSY response
for any requests that cannot be processed in time.12408
Check for PCI brick fault events.
One of the PCI bricks is not present or not
functioning properly12411
Check the network connection between the source
and target.
The migration source was unable to establish a
network connection to the target. The guest will
continue to run on the source.12547
Verify that the source and target network has
enough bandwidth and that the target has
suficient resources.
A migration has failed. The data indicates a
failure code.12548
None.
This message follows a MIGRATION_ABORTED
message.12550
Check the amount of memory in use.Not enough memory is available.12551
Make sure to have HP supported DIMMs
installed.
HP PFM service has detected one or more HP
unsupported DIMMs on this partition.12557
Look at OS logs and crash data to determine why
the system shut down.The OS has caused the system to shut down.12560
124 Management Agents Event Tables