Windows Integrity Management Agents Reference

Find cause of temperature anomaly and fix it.
The temperature inside the server has gone far
outside the factory specified range for normal
operation. To avoid permanent damage to your
server hardware, go and turn off the server
immediately. This event may indicate one of the
following conditions: a failed fan blocked air
vents or poor ventilation around the server open
server chassis cover, or missing drive slot covers
high temperature in the room where the server
resides an unusually hot hardware component
located near one of the server's temperature
sensors753
Find cause of temperature anomaly and fix it.
The temperature inside the server has gone far
outside the factory specified range for normal
operation. To avoid permanent damage to your
server hardware, go and turn off the server
immediately. This event may indicate one of the
following conditions: a failed fan blocked air
vents or poor ventilation around the server open
server chassis cover, or missing drive slot covers
high temperature in the room where the server
resides an unusually hot hardware component
located near one of the server's temperature
sensors754
Find cause of temperature anomaly and fix it.
The temperature inside the server has gone
outside the factory specified range for normal
operation. You should quit applications and
power down the server to protect its hardware
from damage. This event may indicate one of the
following conditions: a failed fan blocked air
vents or poor ventilation around the server open
server chassis cover, or missing drive slot covers
high temperature in the room where the server
resides an unusually hot hardware component
located near one of the server's temperature
sensors755
Find cause of temperature anomaly and fix it.
The temperature inside the server has gone far
outside the factory specified range for normal
operation. To avoid permanent damage to your
server hardware, go and turn off the server
immediately. This event may indicate one of the
following conditions: a failed fan blocked air
vents or poor ventilation around the server open
server chassis cover, or missing drive slot covers
high temperature in the room where the server
resides an unusually hot hardware component
located near one of the server's temperature
sensors756
Verify the power supply is plugged in to the
proper voltage for the system.
The AC voltage was lost, or is the wrong range
for the system.757
Connect the power supply to the proper voltage
range.
The AC voltage is connected to the power supply,
but it is not the voltage range required for the
system.758
Reboot system to allow vector to be re-registered.
OS has registered a bad OS_INIT vector or the
data has been lost.5001
Reboot system to allow vector to be re-registered.
OS has registered a bad OS_MCA vector or the
data has been lost.5002
Cycle system power and attempt boot again. If
error re-occurs contact your HP representative
for support.
BMC firmware has locked up or the BMC is
disabled.5003
66 Management Agents Event Tables