Windows Integrity Management Agents Reference

Reboot, if problem persists contact your HP
representative for support.No wakeup vector registered for processor.5091
Reboot, if problem persists contact your HP
representative for support.SFW is unable to determine the FSB speed.5092
If SMBIOS is preventing functionality, reboot. If
problem persists contact your HP representative
for support.SFW failed to build the SMBIOS tables.5098
Reboot if necessary, if problem persists contact
your HP representative for support.The trap nesting limit has been exceeded.5100
Reboot if necessary, if problem persists contact
your HP representative for support.
A invalid trap has been requested or a trap has
not been installed.5101
Reboot or update System FW. If problem persists
contact your HP representative for support.A trap has been taken5102
No action is required.At least one interrupt was not cleared.5103
Reboot or update System FW. If problem persists
contact your HP representative for support.An unexpected external interrupt has occurred.5104
Reboot, if problem persists contact your HP
representative for support.
An interrupt has occurred before setting up the
Interrupt Vector Table.5105
Reboot or update System FW. If problem persists
contact your HP representative for support.Unexpected MCA5106
If at FW boot time, reboot or upgrade System FW.
If problem persists contact your HP
representative for support. If at OS run time,
verify that the OS has properly installed its trap
handler, and that only valid traps are caused.
Investigate what could cause the trap that is
signaled by the event or why the OS has not
properly installed the trap handler. If problem
persists contact your HP representative for
support.
An unexpected trap has occurred. During System
Firmware boot time this indicates the system has
requested a trap that firmware has not registered.
During OS run time it indicates the system has
requested a trap that is not recognized in the OS's
trap table.5107
Reboot or update System FW. If problem persists
contact your HP representative for support.Unknown error.5108
Reboot, update SFW if necessary, if problem
persists contact your HP representative for
support.SFW has detected a PAL Failure.5118
Contact HP support to troubleshoot the problem.
Expected Machine Check Vector not registered
at the time of an Expected Machine Check5119
No action is required.
Software has requested an INIT or the INIT
button has been pressed.5121
Contact your HP representative to check the I/O
host bridge and the I/O backplane.
I/O host bridge failure. An incorrect I/O
backplane is installed.5123
Contact your HP representative to check the
firmware and the I/O backplane.
The firmware needs to be updated. An incorrect
I/O backplane is installed.5124
Update SFW. If problem persists, contact your
HP representative to check the I/O backplane.
The firmware needs to be updated. An incorrect
I/O backplane is installed.5125
Update SFW. If problem persists, contact your
HP representative to check the I/O backplane.
The firmware needs to be updated. An incorrect
I/O backplane is installed.5127
Contact your HP representative to check the I/O
chipset and backplane.Failed I/O chipset. Failed I/O backplane.5130
Contact your HP representative to check the
hot-plug controller and the I/O host bridge.
Hot-plug controller failure. I/O host bridge
failure.5131
Platform Events – Table 2 (Windows System Log Event ID, Cause, Recommended Action) 69