Windows Integrity Management Agents Reference

Contact your HP representative to check the
firmware.Internal firmware error.5132
Replace or reseat the I/O card(s).A failed or improperly seated I/O card is present.5133
Contact your HP representative to check the I/O
CEC.I/O CEC failure.5136
The IO config in the system is unsupported.
Verify that the IO config installed in the system
is one that is supported. If problem persists
contact your HP representative for support.
The power budget for the IO subsystem has been
exceeded.5137
Contact your HP representative to check the
firmware.Internal firmware error.5138
Remove any unsupported I/O cards. Move the
I/O card to another slot.Unsupported I/O configuration.5139
Contact your HP representative to check the
firmware.Internal firmware error.5140
Contact your HP representative to check the I/O
host bridge.I/O host bridge failure.5141
Contact your HP representative to check the
BMC.BMC failure.5142
Reboot. If problem persists, contact your HP
representative to check the I/O controller.I/O CEC failure.5143
Contact your HP representative to check the I/O
chipset.I/O chipset failure.5144
Contact your HP representative to check the
hot-plug slot.The hot-plug controller has failed.5145
Contact your HP representative to check the
hot-plug slot.The hot-plug controller has failed.5146
Reseat IO card. Replace IO card. If problem
persists, contact your HP representative to check
the I/O slot.I/O slot failure.5147
Contact your HP representative to check the I/O
host bridge or the hot-plug controller.
I/O host bridge failure. Hot-plug controller
failure.5148
Contact your HP representative to check the
firmware.Internal firmware error.5149
Contact your HP representative to check the
firmware and the I/O backplane.
Firmware needs to be updated. An incorrect I/O
backplane is installed.5150
Analyze cause of Machine Check using diag's
and EFI tools.A Machine Check has occurred.5152
Reboot, if problem persists contact your HP
representative for support.
The memory area where the MDT is supposed
to be built has an error in it, so the MDT cannot
be built there.5155
Reboot, if problem persists contact your HP
representative for support.
The MDT table is bad because it did not have an
LMMIO entry in it.5156
FW is written such that this event should never
be generated. If the user sees this event, please
contact HP support.
Memory page 0 was slated for deallocation in the
PDT.5157
Reboot, if problem persists contact your HP
representative for support.
FW requested an entry in the MDT, and there
wasn't a large enough chunk of contiguous
memory for the requested size.5158
70 Management Agents Event Tables