Windows Integrity Management Agents Reference
Update to most recent SFW.Internal SFW error.5205
Install DIMMs or Contact HP Support personnel
to troubleshoot the problemNo DIMMs were detected5208
Before this event is sent, FW will output which
ranks it is deallocating and why. Review the
preceding events and refer to the users manual
to correct the memory loading.
FW found memory, but it could not find a
correctly loaded rank.5209
Re-enable the PDT by clearing NVM
FW found memory errors during selftest, but
could not deallocate the page because the PDT is
disabled.5211
No action is needed if user does not want to use
the PDT, otherwise, clear NVM
Informational event indicating that FW will not
use the PDT this boot.5212
Contact HP support personnel to troubleshoot
the problem.NVM write error.5214
Run the 'pdt' command from the EFI shell and
remove/replace the DIMM that has the most PDT
entries. If that doesn't work, contact HP support.
An attempt was made to add an entry to a full
PDT.5216
If this is seen, update SFW.
Memory FW was unable to save or restore the
original error configuration.5218
Contact HP support to troubleshoot the problem.
The rank structure that corresponds to the rankID
in the data field could not be found in the Rank
table, possibly due to NVM corruption.5219
Contact HP support to troubleshoot the problem
An error other than a memory error occurred
during the memory test5237
Upgrade to latest system firmware, or contact HP
support to troubleshoot the problem.The forward progress bits are invalid.5238
Non-memory errors were detected during the
memory test that FW doesn't know how to
handle.5244
The memory test summary word is invalid5245
Update system board with current memory
controller.
Incompatible memory controller and memory
DIMM.5248
Clear NVM. Update PDC. Contact HP support
to troubleshoot the problem
Control bit to skip DIMM distribution check is
set.5250
Clear NVM. Update PDC. Contact HP support
to troubleshoot the problem
Control bit to skip DIMM loading order check is
set.5252
Clear NVM. Update PDC. Contact HP support
to troubleshoot the problem
Control bit to loop on destructive memory test is
set.5253
Clear NVM. Update PDC. Contact HP support
to troubleshoot the problemControl bit to skip DIMM set check is set.5255
Clear NVM. Update PDC. Contact HP support
to troubleshoot the problemControl bit to skip DIMM SPD check is set.5256
Clear NVM Update SFW Contact HP support to
troubleshoot the problem
Control bit to use an alternate memory config are
set.5257
No action is required. The OS has failed to
register the vector or has chosen not to.The OS has not registered an OS_INIT vector.5260
None, the OS has failed to register the vector or
has chosen not to.The OS has not registered an OS_MCA vector.5263
Analyze cause of Machine Check using diagnostic
and EFI tools.Uncorrected Machine Check.5264
72 Management Agents Event Tables