Windows Integrity Management Agents Reference

Replace the UGUY board.A hardware error has occurred.8214
This should not happen. Contact engineering to
diagnose the problem.8216
A CPU on the slave cell could not process an
interrupt in time or establish the diva console.8218
There could be a PD rendezvous error or a
processor on the slave cell failed to respond to
an interrupt in time.8219
Push out a new Group C complex profile.8220
This will lead to a system reset.8238
An unanticipated error occurred. Contact HP
Support personnel to analyze the IPMI FPL log.8239
Report the IP to the firmware team. Reset the
system. This cannot be worked around in the
field.8240
This can be caused by inconsistent profile
information. This can also occur when an
expected cell did not make the original boot of
the partition. Update the complex profile to all
the cells with a correct view of the system and
try to add the cell again.8243
A read error most likely occurred. Look for
preceding chassis codes to determine exact cause.8257
Change the resources on the cell to be compatible
with the existing partition or attempt to OLA a
different cell.OLA cell has incompatible resources.8261
Collect IPMI events and contact HP Customer
Support for assistance.
OLA cell hung during its part of the OLA process.
Consult chassis codes from the OLA cell to
determine what happened. A secondary problem
here is that the root cell attempted to OLA a cell
that could not have sent the Ready to OLA
command (since it hung). This would indicate a
failure on the OS side to correctly handle
OLA-associated interrupts.8263
Attempt the OLA operation again. If failure
continues, gather IPMI event logs and contact HP
Customer Support for assistance.
Interrupt problem. Root cell should not attempt
to OLA a cell until that cell send the Ready to
OLA message, which a cell at BIB cannot have
done.8264
Attempt the OLA operation again, or collect IPMI
event logs and contact HP Customer Support for
assistance.
OLA cell has reached unknown state after
sending Ready to OLA command, or OLA was
attempted on cell that was not ready to OLA.8265
Fabric links between cells may have failed.
Contact HP Customer Support for assistance.
Bad fabric link between OLA cell and cells
already in the partition.8267
Install CPU's with the same speed and cache size.
CPU's of mixed maximum core frequencies are
installed.8269
Contact HP support. Reset cell.Hardware link initialization failed.8271
Try OLAing a different cell. Contact HP Support
personnel to troubleshoot the problem.
Probably something wrong with the cell
hardware.8643
Collect IPMI event logs and contact HP Support.
System FW was unable to add the OLA cell's
memory to the PD address map.Error writing to
PDH space. Likely cell board error8645
92 Management Agents Event Tables