Windows Integrity Management Agents Reference

Gather IPMI event logs and contact HP Support.
Unable to add OLA cell's PDT to the partition
PDT.Error accessing PDH space. Check fabric
connection between OLA cell and core cell.8646
Collect IPMI events and contact HP Support.
Unable to write registers on the CC. Check cell
board and system fabric.8647
check CC, XBC, reset cell, reset backplaneCC to XBC link init failure.8648
Report the IP to the firmware team. Reset the
system. This cannot be worked around in the
field.8652
Check XBC, CC, backplane8676
Check XBC, CC, backplane8677
contact your HP service representative8679
This is an internal system firmware error. Update
system firmware or contact a system firmware
representative.
The PCI component could not create a device tree
node.8690
This is an internal system firmware error. Update
system firmware or contact a system firmware
representative.
The PCI component experienced an internal
system firmware error while scanning the PCI
bus.8691
Reseat or replace the PCI bridge card.
The PCI component could not initialize a P2P
bridge registers, probably due to faulty hardware.8692
Remove one or more PCI cards to reduce resource
requirements; check for faulty cards that are
requesting more resources than they need.
The PCI component had insufficient IO port space
resources to support the installed PCI cards.8693
Remove one or more PCI cards to reduce the
MMIO requirements; check for a PCI card
requesting more MMIO resources than it needs.
The PCI component had insufficient MMIO space
to support the installed cards.8694
Correct any previous errors Invalidate NVM and
reset replace the cell board
An error was while initializing the SBA firmware
structures8709
Correct any previous errors Replace the I/O
backplane
An error was discovered with the SBA during
discovery8710
Replace the failed IO backplane.
The SBA component could not reset one or more
LBA ropes, probably due to faulty hardware.8711
Re-install or replace the cables; replace the IO
backplane.
The SBA IO link could not be initialized, probably
due to cable installation errors or faulty hardware.8712
Verify proper cable connection, repair/replace
the cables.An SBA IO cable error has been detected.8713
Either power on the IO chassis or ignore the error
if it is powered off by design.Connected IO chassis is powered off.8714
This is an internal system firmware error. Update
system firmware or contact a system firmware
representative.The LBA component initialization routine failed.8715
Replace the I/O backplaneError while writing the LBA phase data8716
Replace the I/O backplaneError while writing the LBA phase data8717
Check other events for the error being generated
replace either the PCI card or the I/O backplaneUnable to clear an error in the LBA8718
This is an internal system firmware error. Update
system firmware or contact a system firmware
representative.
The LBA component could not generate error
logs.8719
replace I/O backplaneThe wrong backplane type was detected8720
Platform Events – Table 2 (Windows System Log Event ID, Cause, Recommended Action) 93