Windows Integrity Management Agents Reference

replace I/O backplaneUnable to configure the LBA8721
Reseat or replace the faulty card.
Could not scan the card in a populated slot.
Typically caused by an improperly installed or
faulty PCI card.8722
reset Update to latest recipeUnable to obtain semaphore8723
Allow the OLA cell to reboot to BIB, then try the
OLA operation again. Or, collect IPMI event logs
and contact HP Customer Support for assistance.
System firmware was unable to lock either the
global or the micro semaphore.8745
Probably caused by lots of PDT entries, or no
main memory present.8747
Update the complex profile to include the new
cell.
Cell was issued an OLA command without first
updating the complex profile to reflect its slot as
configured in the partition.8752
Invalidate NVRAM and reset.8756
Collect IPMI events and contact HP Support.Couldn't communicate with OLA cell.8757
Firmware is taking too long to process requests.8758
Contact HP Support personnel to troubleshoot
the problem.
The PDH FPGA IPR is not cleared after a
MAX_RD_CLR_IPR_TRIES on a cell.8761
Contact HP Support personnel to troubleshoot
the problem.
PDH FPGA IPR is not cleared after a number of
PDC attempts.8762
Collect IPMI events and contact HP Support.
Core cell data could not be accessed/fabric
connections went bad8763
add or replace dimms in the specified echelon
the specified echelon is not fully populated and
is not usable8768
Contact HP Support personnel to analyze the
fabric.
An invalid port number has been provided. The
port number will be converted to an internal port
and processing should continue.8771
Contact HP Support personnel to analyze the
fabric.
An invalid port number has been provided. The
port number will be converted to an internal port
and processing should continue.8772
Many possible causes, repair / replace the
appropriate part.8784
Service / replace the appropriate part of, or the
entire backplane.8787
Needed information could not be obtained. Reset
the MP.8797
FW MCA code uses this
PAL_SET_PROC_FEATURES to escalate future
MCA to BINIT. This event id when emitted
during an MCA processing means that any
subsequent global MCA would not cause all the
processors in the PD to MCA again.8798
This happens because of the NVRAM is full with
unconsumed error logs. Clear the error logs.8806
This shouldn't be occur. But in case it does than
clear the error logs of this event type from the
nvram.8807
94 Management Agents Event Tables