+3 1HW5$,' 0 6XSSOHPHQW IRU ,QWHO ,WDQLXP 3URFHVVRU )DPLO\ +3 6HUYHUV 8VLQJ ELW 0LFURVRIW :LQGRZV April 2003 (Second Edition) Part Number 5917-4215
© 2003 Hewlett-Packard Development Company, L.P. Microsoft®, Windows®, and Windows NT® are U.S. registered trademarks of Microsoft Corporation. Intel® Itanium™ Processor Family is a trademark of Intel Corporation in the U.S. and other countries and is used under license. Hewlett-Packard Company shall not be liable for technical or editorial errors or omissions contained herein. The information in this document is provided “as is” without warranty of any kind and is subject to change without notice.
Contents Introduction ........................................................................................................................ 5 System and NetRAID-2M Requirements........................................................................... 5 Intel Itanium Processor Family HP Server and HP NetRAID-2M Support Matrix ..................................... 5 Available EFI Utilities .........................................................................................................
Introduction This supplemental guide describes using the HP NetRAID-2M (product number P7749A) dual channel, Ultra160 accessory with a 128 MB cache configuration with Intel® Itanium™ Processor Family HP Servers using 64-bit Microsoft® Windows® Server 2003. This supplement is in addition to the information found in the HP NetRAID-1M and NetRAID-2M Installation and Configuration Guide that ships with your HP NetRAID-2M product.
Available EFI Utilities EFI shell utilities specific to the NetRAID-2M are included in the HP Smart Setup DVD under \efi\io_cards\netraid directory and may be executed from the EFI Shell command line. The utilities are: • HPCTRM.efi. This is a menu-based RAID Configuration utility. Most of the functionality and "look-and-feel" is the same as the - NetRAID Express Tools utility for IA-32 systems.
1. Power on the server and insert the HP Smart Setup DVD into the DVD drive. If the server boots to the HP Smart Setup DVD main menu, skip to step 3. If the server boots to the EFI Boot Manager menu, select Bootable DVD, if available, and skip to step 3. If the server boots to the EFI Boot Manager menu, and you do not see a Bootable DVD option available, do the following to set the DVD as a bootable device and to launch the HP Smart Setup DVD interface: a.
7. When the Maintain Firmware screen is displayed, compare the HP NetRAID-2M card’s firmware version that you made a note of against the Version on the DVD column. If the “Version on DVD” is higher than the one you have written, flash the HP NetRAID-2M firmware. Installing the Operating System with the HP NetRAID-2M as the Boot Controller 1.
You may run the setup program from any network connected PC running Windows (NT4.0 or 2000). For more details about using the NetRAID Assistant utility, refer to the HP NetRAID1M and NetRAID-2M Installation and Configuration Guide. Installing the NetRAID-2M Management Software Agent SNMP management agents allow management software (such as HP OpenView, HP Insight Manager 7) to obtain details about how your server is functioning.
