hp workstations zx6000, hp server rx2600 - operation and maintenance guide

System Configuration
Management Processor (MP)
Chapter 3
124
17. Enter the Web Console Port Number. To do this, provide the
“<web_console_port_number>” and press Enter in response to the following prompt:
Enter new Web Console Port Number: <web_console_port_number>
<web_console_port_number>
New Web Console Port Number: will be: <web_console_port_number>
Confirm? (Y/[N])
18. Confirm that the new Web Console Port Number is correct. To do this, type “y” and
press Enter in response to the following prompt:
Confirm? (Y/[N]) y
y
-> Web Console Port Number: will be updated.
Current configuration:
MAC Address : 0x00306e22a4b1
Auto Negotiate : Enabled
Full Duplex : Enabled
100BaseT : Enabled
Do you want to modify the LAN hardware configuration? (Y/[N])
19. Answer the following prompt that asks if you want to modify the LAN hardware
configuration by typing “n” and pressing Enter:
CAUTION If you answer “y,” you should never turn off “Undo Negotiate.” It will lock the system.
Do you want to modify the LAN hardware configuration? (Y/[N]) n
n
-> Settings have been updated.
-> Reset the MP for LAN configuration to take effect.
-> Use the R option of the XD command to reset the MP.
MP Host Name: <new_host_name>
MP>
20. Ensure that the LAN configurations take effect. To do this, type “xd” at the MP
prompt and press Enter. The following information is displayed:
MP> xd
xd
Non destructive tests:
1. Parameters checksum
2. I2C access (get Power Monitor status)
3. LAN access (PING)
4. Modem selftests
5. Secondary I2C access (get System status)
Type R to reset the MP or [Q] to quit the diagnostic menu.
-> Choice: