hp workstations zx6000, hp server rx2600 - operation and maintenance guide

System Configuration
Management Processor (MP)
Chapter 3
125
21. Reset the MP. To do this, type “r” and press Enter in response to the following
prompt:
Type R to reset the MP or [Q] to quit the diagnostic menu.
-> Choice: r
r
The MP is now being reset...
The following information will be displayed when the MP is reset:
HP Management Processor
Firmware Revision kdEv0131 Jan 31 2002,14:43:43
(c) Copyright Hewlett-Packard Company 1999-2001. All Rights Reserved.
Type Ctrl-B to activate the MP Command Interface.
22. Close your Windows based terminal emulation program, and you will be ready to
telnet to this system from another remote system.
Method Two: Entering the MP Command Mode through the LAN
To get to the MP command mode, you need to follow these steps:
1. Complete the steps in the section “Setting Up a LAN Connection to the Management
Card.“
2. Logon to the system with the <new_host_name> you created in the section “Setting
Up a LAN Connection to the Management Card.” To do this, create a terminal
window on your remote system’s display and at the shell prompt type:
C:\> telnet <new_host_name>
3. Watch the Management Card boot the MP command mode prompt. You will see the
following information displayed on the screen:
HP Management Processor
Firmware Revision kdEv1026 Oct 26 2001,10:28:32
(c) Copyright Hewlett-Packard Company 1999-2001. All Rights Reserved
Type Ctrl-B to activate the MP Command Interface