hp workstations zx6000, hp server rx2600 - operation and maintenance guide

System Configuration
Management Processor (MP)
Chapter 3
127
MP Commands
The MP commands allow you to configure your server or workstation either from a local
console or remote console. Please keep in mind that these commands work only with the
Management Card.
There are five categories of MP commands:
• Status commands
• Server control commands
• General MP configuration commands
• MP port configuration commands
• Connections commands
The subsequent sections are the categories of MP commands that are available for your
use. The commands listed under each of these categories are described in more detail
online. To get details for any of these commands type the command name at the MP help
prompt and press Enter.
Here are the steps required for getting help on any of the MP commands:
1. Enter the MP command mode as described in the section “Method One: Entering the
MP Command Mode through the Serial Console” or “Method Two: Entering the MP
Command Mode through the LAN.”
2. Execute the MP help command. To do this, type “he” at the MP prompt and press
Enter.
MP> he
3. Enter the command name at the MP help prompt and press Enter.
Status Commands
This set of commands provides status on the server and the MP. See Table 3-15.
Table 3-3 Status Commands
Command Description
CL Console history
DF Display Field Replaceable Unit ID
LS LAN status
MS Status of the modem
PS Power management module status
SL Status Logs
SR Display all firmware revisions
SS System’s processor status
VFP Virtual front panel display