hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the Tower System’s Front Access Panel
Chapter 2
40
Removing and Replacing the Tower System’s Front
Access Panel
You will need to remove the front access panel to get to the power supplies or the optical
drive. The front access panel will also need to be replaced when you are done accessing
these system components. This section covers how to do these tasks.
Removing the Tower System’s Front Access Panel
Place your fingers in the indentation at the top of the front access panel and rotate it
outward at an approximate 45 degree angle with the front of the system. See Figure 2-7.
Next lift the panel’s retaining slots off of their retaining tabs.
Figure 2-7 Install the Front Panel
Replacing the Tower System’s Front Access Panel
To replace the system’s front access panel reverse the process covered in the section
“Removing the Tower System’s Front Access Panel.” See Figure 2-7.
Front
Access
Retaining Tabs
Retaining Slots
Panel
Front of
System