hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the Rack System’s Access Panel
Chapter 2
42
3. Rotate the access panel’s blue release lever toward the back of the system and slide
the panel toward the back of the system. Next, lift the panel off the system chassis.
See Figure 2-9.
Figure 2-9 Removing the Metal Top Cover
Replacing the System’s Access Panel
1. Secure any wires or cables in your system so they will not get cut or interfere with
the replacement of the access panel on the system’s chassis.
2. Align the access panel’s front edge with the alignment mark on the system’s optical
drive bay area. Next, grasp the cover’s blue release lever and slide the panel toward
the front of the system. When the release lever snaps in place, the cover is secure on
the system. See Figure 2-10.
Figure 2-10 Replacing the Metal Top Cover
3. Slide the system into the rack enclosure (see Figure 2-9) and reconnect the power
cable(s) and turn on the system.
Guide-rail Release Clips
Alignment Mark
Metal Top Cover’s Front Edge