hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing a Rack System’s Front Access Panel
Chapter 2
43
Removing and Replacing a Rack System’s Front Access
Panel
You will need to remove the front access panel to get to the power supplies or the optical
drive. The front access panel will also need to be replaced when you are done accessing
these system components. This section covers how to do these tasks.
Removing the Rack System’s Front Access Panel
Press in on the retaining clips located on the right-side of the front panel. Rotate the
front panel outward to an angle of approximately 45 degrees and pull the panel’s
retaining slots off of its retaining tabs on the system chassis. See Figure 2-11.
Figure 2-11 Removing the Front Panel
Replacing the Rack System’s Front Access Panel
Position the right-side front panel at approximately 45 degrees to the front of the system
and the front panel retaining slots onto the chassis retaining tabs. Rotate the front panel
inward until it snaps in place. See Figure 2-11.
Retaining Tabs
Retaining Clips
Front Access Panel
Retaining Slots