hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing Memory
Chapter 2
48
3. Press down on the memory module’s retaining clips and lift the module by its left
and right edges out of its memory slot. See Figure 2-17. Always store the removed
memory modules in a static-free container for future use.
To replace or install a memory module, reverse this procedure. Note that the memory
module is keyed and can only be inserted in one direction. When the memory module
is correctly seated, you will feel the memory module’s retaining clips lock in place.
Figure 2-17 Removing a Memory Module
4. Replace the system’s access panel(s) (refer to page 37 or page 41). Reconnect all of
the power and external cables.
5. Execute the info mem command at the Extensible Firmware Interface (EFI) shell
prompt to verify your memory configuration. For more information on EFI, see
Chapter 3 of this document.
1: Press down on the retaining clips 2: Lift card out of memory slot