hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing an Audio Card
Chapter 2
53
Replacing an Audio Card
To replace an audio card, complete the following steps:
1. Turn off the system and disconnect all power and external cables.
2. Follow steps two through four of the section “Removing an Accessory Card” in this
chapter (refer to page 49 for instructions).
3. Insert the audio card into a PCI card slot. See Figure 2-23.
4. Connect one end of the audio cable to the audio card and the other end to the audio
connector on the PCI backplane card. See Figure 2-24.
Figure 2-24 Replacing the Audio Card’s Cable
5. Ensure that the audio cable is properly installed by connecting headphones to the
audio OUT jack on the audio card and playing audio media in the optical device.
Figure 2-25 Installed Audio Card and Cable
6. Complete steps six through nine of the section “Replacing an Accessory Card” in this
chapter. See page 51.
Audio Connector on Audio Card
Audio Connector on PCI Backplane
Audio Cable
Audio
Card