hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the PCI/AGP Backplane
Chapter 2
55
Replacing the PCI/AGP Backplane
To replace the PCI/AGP backplane follow these steps:
1. Place the PCI/AGP backplane in the PCI/AGP cage by aligning the cage’s standoffs
with the holes on the PCI/AGP backplane. When sliding the board onto the standoffs,
slide it in the direction of the white arrows. See Figure 2-28 and Figure 2-29. Next,
secure the PCI/AGP Backplane by screwing in its mounting screws. See Figure 2-28
and Figure 2-29.
Figure 2-28 Replacing the PCI/AGP Backplane (for the zx6000)
Figure 2-29 Replacing the PCI Backplane (for the rx2600)
2. Complete steps five through nine in the section “Replacing an Accessory Card” found
in this chapter. See page 51.
PCI Board
Mounting Screws
Intrusion Switch
Slide Card Inward
Slide Card to the Right
PCI Backplane
Mounting Screws
Intrusion Switch
Bulkhead
End
Slide Card Inward
Slide Card to the Right