hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing an Optical Drive
Chapter 2
58
Replacing an Optical Drive
To replace an optical drive in your system, follow these steps:
1. Turn off the system and disconnect all power and external cables.
2. Remove the system’s access panel(s) (refer to page 37 or page 41 for instructions).
3. Slide the optical drive into the optical drive bay until it stops sliding. See
Figure 2-33.
Figure 2-33 Replacing the Optical Drive in the Optical Drive Bay
4. Ensure that the retaining clips on both sides of the optical drive have snapped in
place. To do this, grasp both sides of the drive without pressing in on the retaining
clips and pull outward. If you can pull outward on the optical drive without it sliding
out of its bay, the optical drive is securely in place.
5. Connect the IDE cable on the back of the optical drive. See Figure 2-30.
6. Replace the system’s access panel(s) (refer to page 37 or page 41). Reconnect all of
the power and external cables.
7. Turn the system on and verify that the optical drive has been properly installed. To
do this, execute the info io command at the Extensible Firmware Interface (EFI)
shell. For details on the info io command, read the chapter “System
Configuration” in this document.
Optical
Drive
Optical Drive
Bay