hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories

Removing and Replacing a Hard Disk Drive

Chapter 2

3. Pull outward on the release lever. See Figure 2-36. This will remove the hard disk

drive from the system.

Figure 2-36 Removing the Hard Disk Drive from the System

Replacing a Hard Disk Drive

To replace a hard disk drive in a tower or rack system, follow these steps:

1. Insert the hard disk drive into an empty hard disk drive bay slot and push inward on

the release lever until the hard disk drive no long slides inward. See Figure 2-36.

Please note that you must leave the release lever in the open position, as shown,

when you push the hard disk drive into the system.

2. Secure the hard disk drive by pushing in on the hard disk drive’s release lever. This

makes sure the hard disk drives connector is seated properly in the hard disk drive

backplane connector. See Figure 2-35.

Release Lever

Tower System Rack System