hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing a Power Supply
Chapter 2
61
Removing and Replacing a Power Supply
This section explains how to remove and replace a power supply. This system has two
power supply bay areas for systems that require redundant supplies.
Please note that the power supplies are hot-swappable, which means they can be
removed and replaced without turning off the system. This assumes that you have two
power supplies installed in your system and that one of them is still working when you
remove the defective supply.
To determine which power supply failed, you would go the table “Power Supply FAULTS”
in the section “Using the System’s LEDs and e-buzzer to Troubleshoot” found in the
chapter “Troubleshooting” in this document.
Removing a Power Supply
To remove your power supply, follow these steps:
1. Remove the front access panel from the system’s chassis. To remove the tower
system’s front access panel, place a finger in the indentation at the top of the
system’s panel and pull outward. See Figure 2-37. To remove the rack system’s front
access panel, press in on the two retaining clips on the back side of the front access
panel and pull outward on the panel. See Figure 2-37.
Figure 2-37 Removing the System’s Front Access Panel
Indentation for Your Finger
Tower System
Rack System
Retaining Snaps
Retaining Clips