hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories

Removing and Replacing a Power Supply

Chapter 2

Replacing a Power Supply

To replace your power supply, follow these steps:

1. Complete steps one through three of the section “Removing a Power Supply” on

page 61.

2. Use the power supply’s release lever to slide it into the system. See Figure 2-40. Note

that the release lever must be open to allow the power supply to be slid into place.

Figure 2-40 Slide the Power Supply into the System

3. Push in on the power supply’s release lever to lock its retaining clip in place. See

Figure 2-38.

4. Replace the tower system’s front access panel, insert the retaining tabs on the

system’s chassis into the retaining slots on the front panel and swing the panel

toward the system’s chassis until it snaps in place. See Figure 2-41. To replace the

rack system’s front access panel, insert the retaining tabs of the system’s chassis into

their corresponding slots on the panel. Swing the front access panel in toward the

system’s chassis until it snaps in place. See Figure 2-41.

Figure 2-41 Replacing the System’s Front Access Panel

Power Supply Release Lever

Tower System Rack System

Desk-side System

Rack-mounted System

Retaining

Tabs and

their Slots

Retaining

Tabs and

their Slots