hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the System Fans
Chapter 2
66
Replacing a System Fan
To replace a system fan, follow these steps:
1. Grasp the replacement fan module with your index finger and thumb and insert it
into its fan slot. See Figure 2-43 and Figure 2-44.
2. Replace the system’s access panel within four minutes to prevent damage to the
system components (refer to page 37 or page 41 for instructions).
3. Verify that the fan has been properly installed. To do this, observe the LED signals
on the front of the system for the appropriate fan information. LED information can
be found in the section “Troubleshooting with the Systems LEDs and e-buzzer” in
the chapter on troubleshooting.