hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the Processor Airflow Guide
Chapter 2
69
5. Disconnect the power cable that is connected to the front half of the airflow guide
from the system board and lift the front half of the airflow guide out of the system.
See Figure 2-48.
Figure 2-48 Removing the Front Half of the Airflow Guide
Replacing the Processor Airflow Guide
To replace the processor airflow guide, follow these steps:
1. Turn off the system if it is not already turned off. Disconnect all power cables and
any LAN or telecommunications cables.
2. Remove the system’s access panel(s) if it has not been already removed (refer to
page 37 or page 41 for instructions).
3. Align the release latch of the front half of the airflow guide over the release latch
post and snap it in place. Next, connect the front half of the airflow guide’s power
connector to its connector on the system board. See Figure 2-47. Replace system fans
1A and 1B (refer to page 65 for instructions).
4. Place one finger in the opening on top of the processor airflow guide, and grasp the
back end of the airflow guide with your hand. Next, insert the processor airflow
guide into the system. See Figure 2-49. Connect the power module’s cable and place
the cable in its cable clips. Insert the two airflow guide retaining tabs into the two
slots on the front half of the airflow guide.
Figure 2-49 Replacing the Processor Airflow Guide
5. Replace the system’s access panel(s) and metal side/top cover (refer to page 37 or
page 41). Reconnect all of the power and external cables.
Front Half of
Airflow Guide
Power Connector for Front
Half of Airflow Guide
Retainer Clips
Processor Airflow
Guide
Front Half of
the Airflow
Guide
Cable Clips