hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories

Removing and Replacing the Management Card

Chapter 2

Removing and Replacing the Management Card

This section explains how to remove and replace the optional Management Card. This

card adds these connectors to your system: 10/100 Management LAN connector, 15-pin

VGA connector and 25-pin Serial connector.

Removing the Management Card

To remove the Management Card, follow these steps:

1. Turn off the system and disconnect all power and external cables.

2. Remove the system’s access panel(s) (refer to page 37 or page 41 for instructions).

3. Unscrew the two power connector mounting screws and remove the power

connectors from the back of the system. See Figure 2-50.

Figure 2-50 Removing the Power Connectors

4. Unscrew the two mounting screws that connect the Management Card to the

internal chassis post. Next, unscrew the two external mounting screws that are

located on both sides of the 25-pin Serial connector as shown below. See Figure 2-51.

Figure 2-51 Unscrew the Management Card Mounting Screws

Power Connector Mounting Screw

Power Connectors

Internal Mounting Screws

External Mounting Screws