hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories

Removing and Replacing the Management Card

Chapter 2

5. Disconnect the Management Card connector and remove the Management Card

from the system by grasping it by its edges. See Figure 2-52.

Figure 2-52 Disconnecting the Management Card Connector and Removing the

Card

6. Replace the Management Card blank, if available, on the system’s chassis. This

blank is used to ﬁll the holes left by the 10/100 Management LAN, 15-pin VGA and

25-pin Serial connectors, and it is not necessary for the system to function. To install

the blank, insert the blank’s retaining tab into its slot on the system’s chassis. See

Figure 2-53.

Figure 2-53 Replacing the Management Card’s Blank

Management Card Connector

Management Card

Blank’s Retaining Tab

and Slot

Management Card Blank