hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the Management Card
Chapter 2
72
7. Push the Management Card blank against the inside of the chassis and screw in the
blank’s mounting screw on the external connector side of the system’s chassis. See
Figure 2-54.
Figure 2-54 Completing the Installation of the Management Card Blank
8. Replace the system’s access panel(s) (refer to page 37 or page 41). Reconnect all of
the power and external cables.
Replacing/Installing the Management Card
To replace the Management Card, follow these steps:
1. Turn off the system and disconnect all power and external cables.
2. Remove the system’s access panel(s) (refer to page 37 or page 41 for instructions).
3. Unscrew the mounting screw for the Management Card blank, which is located on
the external connector side of the system’s chassis. See Figure 2-54.
4. Remove the Management Card blank’s retaining tab out of its slot on the system
chassis and remove the blank from the system. See Figure 2-53.
5. Replace the Management Card in the system by grasping its edges and placing it on
the two Management Card posts. You will need to push the card’s 10/100
Management LAN, 15-pin VGA and 25-pin Serial connectors through their openings
on the back of the system. Next, connect the Management Card cable to its connector
on the system board. See Figure 2-52.
6. Screw in the two mounting screws that connect the Management Card to the
internal chassis post. Next, screw in the two external mounting screws that are
located on both sides of the 25-pin Serial connector as shown below. See Figure 2-51.
7. Replace the two power connectors. See Figure 2-50.
8. Replace the system’s access panel(s) (refer to page 37 or page 41). Reconnect all of
the power and external cables.
Mounting Screw for the Blank