hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories

Removing and Replacing the LED Status Panel

Chapter 2

Removing and Replacing the LED Status Panel

This section explains how to remove and replace the LED status panel. This card

contains a set of LEDs and a buzzer that provide status and troubleshooting

information.

For information on the status panel LEDs, see the section “Troubleshooting with the

Systems LEDs and e-buzzer” in the chapter “Troubleshooting” in this document.

Removing the LED Status Panel

To remove the LED status panel, follow these steps:

1. Turn off the system and disconnect all power cables.

2. Remove the system’s access panel(s) (refer to page 37 or page 41 for instructions).

3. Disconnect the LED status panel’s controller cable. See Figure 2-55.

Figure 2-55 Disconnect the LED Status Card’s Controller Cable

4. Unscrew the two LED status panel mounting screws and remove the panel. See

Figure 2-56.

Figure 2-56 Remove the LED Status Card

LED Controller

Cable

LED Status

Panel

Mounting Screws

LED Status Panel