hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing a Processor
Chapter 2
77
7. Unscrew the four heatsink captive screws using the special processor tool that was
shipped with your replacement processor. See Figure 2-60. Performing this task
allows you to slide the sequencing retaining plate toward the back of the system.
Sliding the sequencing retainer plate toward the back of the system opens up the
hole in the edge of the turbo fan’s heatsink for insertion of the special processor tool
into the processor locking mechanism. See Figure 2-60.
Figure 2-60 Unscrew the Turbo Fan’s Heatsink Captive Screws
8. Unlock the processor locking mechanism using the special processor tool shipped
with your replacement processor assembly. To do this, you need to insert the tool into
the hole that runs down through the edge of the turbo fan’s heatsink and rotate the
special processor tool 180 degrees counterclockwise. See Figure 2-61.
Figure 2-61 Unlock the Processor Locking mechanism
Captive Screw
Turbo Fan’s
Heatsink
Sequencing
Retaining Pla
te
Slide the plate left to open
access hole.
Slide the plate right to close
access hole.
Access Hole
S
equence Plate
S
equence Plate Access Hole
Special Processor Tool
Processor
Locking
Mechanism