hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing a Processor
Chapter 2
78
9. Remove the turbo fan heatsink and processor from the system. See Figure 2-62.
Figure 2-62 Remove the Turbo Fan Heatsink and the Processor
Replacing/Installing a Processor
To replace a processor or add a second processor, follow the steps provided in this section.
Note that you must have a processor in slot CPU0 before installing one in slot CPU1.
1. Complete steps one through nine of the section “Removing a Processor” in this
chapter if you need to replace the current processor with a new one. Next, continue
with step 2. If you are adding a processor in CPU1’s empty socket, continue with step
two.
2. Ensure that the processor’s locking mechanism is rotated into the unlocked position.
See Figure 2-63.
3. Check to ensure that no processor pin is bent. Next, use the four locator posts on the
heatsink and the turbo fan’s power cable to properly align the fan and processor
assembly on the system board. The four locator posts will fit in locator holes on the
system board’s processor mount. The turbo fan’s power cable must be positioned so
that it is located on the side of the heatsink that faces the front of the system. See
Figure 2-63.
Figure 2-63 Replace the Turbo Fan and Processor Assembly
Turbo Fan
Heatsink
Turbo Fan
Heatsink
Heatsink
Locator Posts
(two on opposite
side)
Locator Holes
for Heatsink posts
(two on opposite
side)
Unlocked
Processor Locking
Mechanism